Oregon OSHA Health and Safety

RESOURCE

April 2016

Ask Technical

Does Oregon OSHA require that a partially exposed shaft on a motor - such as the one in this picture - be completely enclosed with a guard? The gap is too small for a person's fingers to contact the spinning shaft.

machine with unguarded spindle shaft

The entire shaft must be guarded. Even if the gap is too small for a person’s fingers to contact the shaft‚ loose clothing‚ lanyards for identification badges‚ or long hair could get caught.

The rule that applies in this case says:

“All exposed parts of horizontal shafting 7 feet or less from floor or working platform‚ excepting runways used exclusively for oiling, or running adjustments‚ shall be protected by a stationary casing enclosing shafting completely or by a trough enclosing sides and top or sides and bottom of shafting as location requires.”

You will find the rule in Division 2‚ Subdivision O‚ Machinery & Machine Guarding: 1910.219(c)(2)(i)‚ (Guarding horizontal shafting).

If you want to receive the Resource Newsletter, sign up for future issues here.

Reprinting, excerpting, or plagiarizing any part of this publication is fine with us. Please send us a copy of your publication or inform the Resource editor as a courtesy. If you have questions about the information in Resource, please call 503-378-3272.

For general information, technical answers, or information about Oregon OSHA services, please call 503-378-3272 or toll-free within Oregon, 800-922-2689.